JVC Micro Component System UX-G200 - Manual (Page 22)

19
Daily Operations—Sound & Other Adjustments
(see pages 11 and 12)
Adjusting the Volume:
• Be sure to turn down the volume before connecting or putting
the headphones.
Adjusting the Sound:
• This function also affects the sound through the headphones.
Setting the Clock:
• “AM 12:00” flashes on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If this
happens, set the clock again.
Advanced Disc/USB Mass Storage Class Device
Operations
(see pages 13 to 15)
Programming the Playing Order—Program Play:
• If you try to program a 33rd track, “PROGFUL” appears on
the display.
• While programming steps...
Your entry will be ignored if you have tried to program an item
number that does not exist on the disc (for example, selecting
track 14 on a disc that only has 12 tracks).
Daily Timer Operations (see pages 16 and 17)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the AC power cord
and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote sensor
on the System is blocked.
] Point it at the remote sensor on the front panel.
] Move closer to the System.
] The batteries are exhausted.
No sound is heard from the speakers.
] Speaker connections are incorrect or loose (see page 5).
] Headphones are connected (see page 7).
Radio Operations:
Hard to listen to broadcasts because of noise.
] Antenna connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended or positioned.
UX-G200[J].BOOK Page 19 Tuesday, December 2, 2008 3:05 PM