JVC 3834RV0038A - Manual (Page 10)

Installation and Setup
Tips:
Depending on your TV and other equipment there
are various ways you can connect the player.
Please refer to the manuals of your TV, VCR,
stereo system or other devices as necessary for
additional connection information.
Notes:
The picture and sound of a nearby TV, VCR, or radio may
be distorted during playback. Position the units away from
each other or turn off the unit after removing the disc.
Make sure the DVD+VCR is connected directly to the TV
and tune the TV to the correct video input channel.
Do not connect the DVD+VCR’s AUDIO OUT jack to the
phono in jack (record deck) of your audio system. Do not
connect the DVD+VCR via another VCR. The DVD image
could be distorted by the copy protection system.
Connecting to a TV & Decoder
(or Satellite)
Make one of the following connections, depending on
the capabilities of your existing equipment.
Basic connection (AV)
1. Connect the EURO AV1 AUDIO/VIDEO on the
rear panel of this unit to the SCART input socket
on the TV using a SCART lead (not supplied).
For TV without SCART, connect the yellow VIDEO
OUT jack and DVD/VCR AUDIO OUT jacks of this
unit to the TV.
2. Some TV broadcasters transmit encoded television
signals which you can only see with a purchased
or rented decoder. You can connect such a
decoder (descrambler) to this unit.
Basic connection (RF)
1. Connect the RF antenna cable from your indoor/
outdoor antenna to AERIAL jack on the rear panel
of this unit.
2. Connect the supplied RF antenna cable from the
RF.OUT jack on the rear panel of this unit to your
television’s Antenna Input.
10
Rear of TV
VIDEO IN AERIAL AUDIO INPUT
L R
SCART INPUT
Rear of this unit (Basic connection)
Decoder (or Satellite)