JVC RX-DV31 - Manual (Page 11)

6
English
CAUTION:
SPEAKER
IMPEDANCE
1 OR 2:
16 32
8 16
CAUTION:
SPEAKER
IMPEDANCE
8
16
1 AND 2:
VOLTAGE SELECTOR 110V
127V
230-240V
220V
ANTENNA
AM LOOP
FM 75
COAXIAL AM EXT
FM 75
CO AXIAL
1 2 3
1
2
AM antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
1 Remove the insulation if the AM loop antenna wire is
covered with vinyl.
2 Press and hold the clamp of the terminal (1), then insert
the wire (2).
3 Release the clamp.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. Keep
the AM loop antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna
(not supplied). Before attaching a 75 Ω coaxial cable with a
connector (IEC or DIN45325), disconnect the supplied FM
antenna.
Note:
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause
poor reception.
AM loop antenna
(supplied)
If AM reception is poor,
connect an outdoor
single vinyl-covered wire
(not supplied).
FM antenna (supplied)
If FM reception is poor, connect
outdoor FM antenna (not supplied).
Snap the tabs on the loop
into the slots of the base
to assemble the AM loop
antenna.
Connecting the AM and FM Antennas
Getting Started
01-11_RX-DV31SL[UW]f.p65 03.4.22, 18:55 6