JVC UX-P7 - Manual (Page 10)

– 8 –
Speaker grille
To remove the speaker grille, inserting your fingers at the
top of the speaker grille, pull towards you. Then pull the
bottom towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Connecting Other Equipment
You can connect both of the analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect audio equipment
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
Holes Projections
To remove the speaker grilles
The speaker grilles are removed as the illustrations below.
IN
R L
OUT
AUX
To audio output
Audio equipment
To audio input
By using audio cords (not supplied), connect:
• Between the audio input jacks on the other equipment
and AUX OUT jacks: For recording on the other
equipment.
• Between the audio output jacks on the other equipment
and AUX IN jacks: For playing the other equipment.
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
OPTICAL
DIGITAL
OUT
Before connecting the other equipment,
remove the protective plug from the
terminal.
Protective plug
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
OPTICAL DIGITAL OUT terminal.
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
Now, you can plug the AC power cord.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
To optical digital input
Audio equipment
with an optical digital
input
Voltage mark
VOLTAGE
SELECTOR
110V
127V
220V
230V
-240V
EN01-11.UX-P7[A] 01.5.16, 5:00 PM 8