JVC UX-P7 - Manual (Page 15)

– 13 –
MULTI KEY
Track number Program step number
PRGM
PRGM
SET
Programming the Playing Order of the Tracks
— Program Play
You can arrange the order in which tracks play before you
start playing. You can program up to 20 tracks.
1
Load a CD.
• If the current playing source is not the CD player, press
CD 3/8, then 7 before going to the next step.
2
Press PROG (program).
The PRGM (program) indicator lights up
on the display.
• If a program has been stored in memory, the program is
called up.
3
Press MULTI KEY > or MULTI KEY < to
select the track number, then press SET.
4
Repeat step 3 to program other tracks you
want.
5
Press CD
3/8.
The tracks are played in the order you have
programed.
To stop playing, press 7.
To exit from Program play mode, press 7 before or after
playing. The PRGM (program) indicator goes off. All the
programed tracks will be cleared.
• Disc ejection also erases the program.
To check the program contents
You can check the program contents by
pressing PROG on the remote control. The
programed tracks are shown in the
programed order.
To modify the program
Before or after playing, you can erase the last
programed track by pressing CANCEL on the
remote control.
• Each time you press the button, the last programed track is
erased from the program.
To add tracks in the program before playing, simply select
the track numbers you want to add by following step 3 of the
programming procedure.
• If you try to program the 21st track
“FULL” will appear on the display.
• If the total playing time is 100 minutes or more
The total playing time will not be shown. “– –:– –” will appear.
CANCEL
PROG
CD
PROG
Continued
EN12-15.UX-P7[A] 01.5.22, 2:36 PM 13