Jonsered BB2250 - Manual (Page 11)

English
11
■ FLEXIBLE HOSE AND SWIVEL JOINT
1. Connect the blower and swivel joint with flexible hose. Clamp both ends of the
flexible hose securely with the hardware supplied with the unit.
(1) Flexible hose (2) Swivel joint
(3) clamp (large) (4) Clamp (small)
NOTE
A light lubricant may be used to ease assembly of flexible hose to blower tube.
■
CONTROL HANDLE
1. Set up the handle holder to the swivel joint and tighten the screw on the holder.
When setting up the handle holder, please make sure to match the handle holder to
the convex on the swivel joint as shown in F2.
2. Adjust the position to achieve a comfortable working position, and tighten the
control handle.
(1) Handle holder
(2) Swivel joint
(3) Screw
■
CABLING
• Use the clamp to fasten the cabling to the flexible hose.
(1) Clamp
(2) Cabling
(3) Flexible hose
■
BLOW PIPES
1. Connect the straight pipe and pipe end. Push the pipes together and turn them so
they lock in relaton to one another until the connection is locked.
NOTE
A light lubricant may be used to ease assembly of the blower tube.
NOTE
If longer tube is required, the second straight pipe can be connected
with the first one.
If higher air speed is required, the round blow pipe can be replaced by the
flat nozzle with the second straight pipe.
(1) Flat nozzle.
■
HARNESS
WARNING
The harness must always be worn when working with the machine. Failure to do
so means you will be unable to maneuver safely and this can result in injury to
yourself or others.
A correctly adjusted harness and machine significantly facilitates the work. Adjust the
harness to give the best working position.
Tighten the side straps so that the pressure is evenly distributed across the shoulders.
(2)
(1)
(4)
(3)
F1
F2
F3
(1)
F4
F5
F6
Assembly
BB2250_English.fm Page 11 Thursday, December 10, 2009 1:35 PM