JVC VR-609 - Manual (Page 60)

-- 60 --
VR-609
5.3.2 Alarm Link Setup
・Select condition of Alarm Out. Alarm inputs are 9EA and Alarm outputs are 4EA.
・The above menu will display as checking Alarm Link button.
1) Alarm (left of the above picture) : Sets up which alarm will be output when alarm
occurs. Inputs are 1~9 and possible to select repeatedly.
2) Events (above of right) : Sets up events which will be output alarm signal. There are
Disk Full, Admin, PW Changed, Video Loss, and Motion. Possible to select repeatedly.
3) Alarm Off (below of right) : How to off alarm when alarm occurred.
There are Manual and Auto.
4) Alarm Output Number : The part for selecting output port when signal is in according to
alarm and event setup. Output ports are in rear of product and able to select one of
them.
・Move to previous menu after finish setup by using EXIT button.
Alarm output number
Present output number is 1
5.3.2.1 Alarm
1) Moves by using ▲, ▼ buttons or Jog.
2) Displays alarmed channel. For selecting channel you want to detect, press ENTER
button after moving cursor to detect. Canceling is the same way.
・Alarm Output signal is outputted within approximately 2 seconds after various
alarms are detected.
・When outputs an Alarm Output, "AL" is displayed on the left of the date display.
・The alarm inputs 1-9 follow the alarm input number set-up by Alarm Recording
setup.
!