JVC CA-NXCDR7R - Manual (Page 15)

– 10 –
SPEAKERS
CAUTION :
SPEAKER IMPEDANCE
6 16
R L
R L
FM
COAXIAL
LINE IN
LINE OUT
3CD
DIGITAL OUT
LINE
DIGITAL IN
R L
R L
AM
LOOP
(75 )
ANTENNA
OPTICAL
AM
EXT
SPEAKERS
CAUTION :
SPEAKER IMPEDANCE
6 16
R L
R L
FM
COAXIAL
LINE IN
LINE OUT
3CD
DIGITAL OUT
LINE
DIGITAL IN
R L
R L
AM
LOOP
AM
EXT
(75 )
ANTENNA
OPTICAL
Connecting Other Components
When you connect and use other components, refer also to
the manuals supplied with them.
• DO NOT connect other components while the
power is on.
• DO NOT plug in any component until all
connections are complete.
To connect an analog component such as a cassette
deck
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color-coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
You can enjoy playback and recording on the other
connected component.
To input (REC)
By using audio cords (not supplied), connect:
• Between the audio input jacks on the cassette deck and
the LINE OUT jacks.
• Between the audio output jacks on the cassette deck and
the LINE IN jacks.
To output (PLAY)
Ex.: cassette deck
To connect digital components
• When connecting a digital component equipped with
an optical digital output terminal
The following connection allows you to perform digital-
to-digital recording (through the digital terminals) and
playback of the connected digital component (through
the analog terminals.)
To optical digital output
By using an optical digital cord (not supplied) and an audio
cord (not supplied), connect:
• Between the optical digital output terminal on the other
component and the LINE DIGITAL IN terminal.
• Between the audio output jacks on the other component
and the LINE IN jacks. (This connection is required to
play back sounds through this unit when the source is
“LINE.”)
The digital connection through the LINE DIGITAL
IN terminal can be only used for recording.
• When connecting a digital component to this unit,
always connect it both the LINE DIGITAL IN
terminal and the LINE IN jacks.
Protective cap
Before connecting the
other component, remove
the protective cap from
the terminal.
Audio component with
optical digital output
To output (PLAY)
EN01-12_CA-NXCDR7R[B]_f 01.7.27, 2:42 PM 10