JVC CA-NXCDR7R - Manual (Page 29)

– 24 –
NORMAL
SPEED
dB REC LEVEL
3 2 1
CD
Good No good
Continued
Elapsed playing time
Playing Back the Entire Discs—Continuous
Play
You can play discs continuously.
1
Load discs into 3-CD Changer.
2
Select a disc, and start playback.
On the unit:
1 Press DISC repeatedly to select the disc you want.
2 Press CD
3 / 8.
On the remote control:
Press one of the disc number buttons (CD1, CD2,
and CD3).
CD playback starts from the first track of the selected
disc.
• Without selecting the disc number, pressing
CD
3 / 8 starts playing back the currently selected
CD.
To stop playback for a moment, press CD 3 / 8.
To resume play, press CD
3 / 8 again.
To stop during play, press
7.
To remove the disc, press the corresponding open/close
buttons (
0 CD1, 0 CD2, or 0 CD3) on the unit.
Disc playback sequence in 3-CD Changer
When 3 discs are loaded on the disc trays, they are played in one
of the following sequences.
• When CD 1 is pressed : CD 1
] CD 2 ] CD 3 (then stops)
• When CD 2 is pressed : CD 2 ] CD 3 ] CD 1 (then stops)
• When CD 3 is pressed : CD 3 ] CD 1 ] CD 2 (then stops)
* If no disc is on the disc trays, 3-CD Changer skips such an
empty tray.
If the current disc is a CD Text
You can change the information in the main display. See “To show
the text information recorded on a CD Text” on page 28.
Track No.
Disc No.
The built-in 3-CD Changer can play back both finalized
and unfinalized CD-Rs/CD-RWs. However, some
unfinalized discs cannot be played back because of
their disc characteristics.
Loading Discs
On the unit ONLY:
1
Press one of the open/close buttons (
0 CD1, 0 CD2,
and
0 CD3) for the disc tray you want to load a CD
onto.
The unit automatically turns on and the selected disc
tray comes out.
• If the sliding panel is left open, it moves up
automatically before the disc tray comes out.
2
Place a disc correctly on the
circle of the disc tray, with
its label side up.
• When using a CD single (8 cm), place it on the
inner circle of the disc tray.
3
Press the same open/close button (
0 CD1, 0 CD2,
or
0 CD3) you have pressed in step 1.
The disc tray closes.
When loading more than one disc continuously
Press the open/close button ( 0 CD1, 0 CD2, or 0 CD3) for the
next tray you want to place a disc onto. The first disc tray
automatically closes and the next disc tray comes out.
EN23-28_CA-NXCDR7R[B]_f 01.7.23, 10:00 AM 24