John Lewis JLTDC01 - Manual (Page 14)

14
Setting time delay
3
With the DELAY START button, you can delay the
start of a programme by between 30 minutes (30'
and a maximum of 23 hours (23h).
1. Select the programme
2. Press the DELAY START button as many times as neces-
sary until the required start delay appears on the multi
display, e.g. 12h if the programme is to be started in
12 hours. The DELAY START display is illuminated.
3
If 23h is displayed and you press the button again,
the time delay will be cancelled. The display will
show 0' and then the duration of the selected pro-
gramme.
3. To activate the delay timer, press the START/PAUSE but-
ton. The amount of time remaining until the programme
is set to start is continuously displayed (e.g. 12h, 11h,
10h, … 30
'
etc).
3
Until the start of the programme the drum is moved
at longish intervals to loosen the laundry.
Starting the programme
Press the START/PAUSE button. The programme is started.
The programme progress display and the display showing
the level of dryness show drying progress.
Changing programme
To change a programme which has been selected by mistake
once the programme has started, first turn the programme
selector to OFF and then reset the programme.
3
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the
programme knob, the programme progress display
and the maintenance indicators flash. If an option
button (excluding the ALARM button) is pressed,
Err appears in the multidisplay. The drying pro-
gramme is not however affected by this (laundry pro-
tection).
Removing laundry or loading
laundry when necessary
1. Open loading door
1
Warning! Laundry and drum can become hot. Risk
of burns!
2. Load or remove laundry items.
3. Close the door securely. Lock must audibly lock.
4. Press the START/PAUSE button to continue the drying cy-
cle.
Drying cycle complete / remov-
ing laundry
Once the drying cycle is complete, the END and CREASE
GUARD indicators light up. If the ALARM button has been
pressed, an acoustic signal sounds intermittently.
3
The drying cycles (except for the WOOL pro-
gramme) are automatically followed by an anti-crease
phase which lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This keeps the
laundry loose and free of creases. The laundry can
be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of
the anti-crease phase at the latest to prevent creases
from forming.) If ANTI-CREASE has been selected,
the anti-crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-
fine filter. It is best to use a damp hand for this purpose.
(See “Cleaning and maintenance” section.)
3. Remove laundry.
4. Turn the programme selector to OFF.
Important: After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container
(See section “Cleaning and maintenance”.)
5. Close door.