JVC SP-UXGD7 - Manual (Page 23)

19
Setting the Clock
Without setting the built-in clock, you cannot use the Daily
Timer (see page 33) and Sleep Timer (see the right column).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1 Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected (see page 33).
2 Adjust the hour.
3 Adjust the minute.
Now the built-in clock starts working.
To check the current clock time during play
• While playing a DVD/MP3/DivX, you cannot check the
current clock time (see page 9).
Turning Off the Power
Automatically
To turn off the System after playback is over—
Auto Standby
When Auto Standby is in use, the A.STANDBY indicator
lights on the display. When the disc play stops, the
A.STANDBY indicator starts flashing. If no operation is
done for about 3 minutes while the indicator is flashing, the
System turns off (in standby) automatically.
• Auto Standby does not work while you are listening to
radio (FM/AM) or the external component (AUX/USB).
To turn off the System after a certain period of
time—Sleep Timer
1 Specify the time (in minutes).
• SLEEP indicator also lights up on the display.
2 Wait until the set time goes off.
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the
shut-off time.
Remote
ONLY
Clock
Source information
(at the same time)
Remote
ONLY
A.STANDBY
Canceled
(at the same time)
(at the same time)
(at the same time)
UX-GD7[B]_EN.book Page 19 Wednesday, April 20, 2005 4:59 PM