JVC HR-XVC33UM - Manual (Page 47)

Masterpage:Right-No-Heading
EN
47
Filename [XVC33UM_08DVD.fm]
Page 47 4 August 2003 6:47 pm
VFP function
— Adjusting the picture quality
The VFP (Video Fine Processor) function enables you to adjust
the picture character according to the type of programing,
picture tone or personal preference.
NOTE:
Before you start operation;
The VFP setting screen disappears if no operations are done for
more than about 10 seconds. If the setting screen disappears
before you finish, start from step 1 again.
1 Access the VFP setting menu.
2 Select the VFP mode.
Press w e repeatedly.
● Each time you press w e, the VFP mode changes as follows:
NORMAL]CINEMA]USER 1]USER 2](Back to the
beginning)
NOTE:
You cannot adjust the parameters of “NORMAL” and “CINEMA”.
To adjust picture appearance manually
3 Access USER menu.
4 Select the parameter.
Press rt repeatedly to select a parameter you want to
adjust, then press OK.
● Adjust gradually and confirm picture appearance results are as
preferred.
● VFP menu disappears and the following pop-up window
appears on the TV screen.
5 Adjust the parameter.
Press rt repeatedly to change the setting, then press
OK.
● The current VFP settings appear again.
6 Adjust the other parameters.
Repeat steps 4 and 5 to adjust other parameters.
To return to the normal screen
Press DVD PICTURE.
To activate your setting
Press DVD PICTURE, then press w e repeatedly to select
“USER 1” or “USER 2” that you have changed the
parameters.
Press DVD PICTURE during
playback.
● The current setting appears on
the TV screen.
NORMAL : Select this normally.
CINEMA : Suitable for movie.
USER 1 /
USER 2 :
You can adjust parameters that affect picture
appearance and store settings. Go to step 3.
Press w e repeatedly to
select “USER 1” or “USER 2”.
+0
NORMAL
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
Y DELAY
+0
+0
+0
+0
+3
+0
+0
USER 1
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
Y DELAY
+0
+0
+0
+0
+3
+0
GAMMA
(–4 to +4):
Controls brightness of neutral tints while
maintaining brightness of dark and bright
portions.
BRIGHTNESS
(–16 to +16):
Controls screen brightness.
CONTRAST
(–16 to +16):
Controls screen contrast.
SATURATION
(–16 to +16):
Controls screen color depth.
TINT
(–16 to +16):
Controls screen tint.
SHARPNESS
(+0 to +3):
Controls screen sharpness.
Y DELAY
(–2 to +2):
Controls screen color gap.
+0 GAMMA
+0 GAMMA
XVC33UM_01.book Page 47 Monday, August 4, 2003 7:24 PM