JBM electronic 900 - Manual (Page 13)

Gateway 900 Installation Manual Page 11
This example is Frame Relay with two DLCIs. The first input is: "Please specify the
number of DLCIs supported on this Frame Relay connection"
Enter in number 2
For each network interface do the following:
-
DLCI Number: Enter in the DLCI number. Note the default number is always
16.
-
Interface Name: The Interface name will also have default value. You can leave
it as is or change it. For instance, you could change it to ?chicago? or
?toronto?.
IMPORTANT: If you are using iptables you might want to change the default interface
name to something like "wan0". Iptables and Ipchains don't like "_" in interface name.
e.g.: 'iptables -o wp1_fr16 ...' will give you an error
- Operation Mode: WANPIPE is for IP Routing API is used for custom API
applications.
- DLCI Protocol Setup: In this section leave everything as default.
Unless the ISP has specified specific protocol options such as CIR.
- IP Setup: Put in your IP info as supplied by ISP Enable Default gateway for the
first interface.
7.
Once all network interfaces are setup keep hitting the BACK button until Main Menu is
reached.
Then select EXIT and save the config file.
The new config file will be located in /etc/wanpipe directory.
8. Start
the device:
wanrouter start wanpipe1
Note: The card doesn't have to be connected to start the wanrouter.
9.
Troubleshooting the driver load process
All wanpipe driver events will be recorded in /var/log/messages.
© JBM Electronics Co. 1-800-489-7781 www.jbmelectronics.com