JBM electronic 900 - Manual (Page 14)

Gateway 900 Installation Manual Page 12
Thus if errors occur, first check /var/log/messages to find out what exactly went wrong
with the drivers startup.
Once the device is started you should see a "link connecting" message. This
message indicates that the card was been configured successfully and that the link is
trying to connect.
Reset Function
The Gateways have a Reset Button that can be used to perform the following function:
Function Action
Restart Press and release the switch. The Gateway will clear its buffers
and restart the program. All current sessions will be closed.
LED Status Indicators
The Gateways have LED indicators that can be used to isolate problems. The LEDs indicate
the following activity:
LED COLOR FUNCTION NORMAL STATUS
Power Yellow Signifies that power is available to
the Gateway Always On
TD Red Indicates that data is being
transmitted from the attached device Blinks during data
transmission
RD Green Indicates that data is being received
from the attached device Blinks during data
reception
Link Green Indicates there is a Link with the
Ethernet network. On when connected
Transmit Red Indicates that data is being
transmitted to the Ethernet
connection. Blinks during data
transmission
Receive Green Indicates that data is being
transmitted by the Ethernet
connection. Blinks during data
reception.
© JBM Electronics Co. 1-800-489-7781 www.jbmelectronics.com