JBM electronic 900 - Manual (Page 18)

Gateway 900 Installation Manual Page 16
Danemark
ƒ La prise mâle d’alimentation doit respecter la section 107-2 D1 de la norme DK2 1a ou DK2 5a.
Suisse
ƒ La prise mâle d’alimentation doit respecter la norme SEV/ASE 1011.
Europe
ƒ La prise secteur doit être conforme aux normes CEE 7/7 (“SCHUKO”)
ƒ Le cordon secteur doit porter la mention <HAR> ou <BASEC> et doit être de type H03VVF3GO.75
(minimum).
Technical Information
Related Standards
The Gateway 900, 905 and 910 have been designed to the following standards:
EMC
FCC PART 15, SUBPART B, Class A
CISPR 22/EN 55022, Class A
IEC 61000-4-2/EN 61000-4-2
IEC 61000-4-3/EN 61000-4-3, ENV 50204
IEC 61000-4-4/EN 61000-4-4
EN 61000-4-5
IEC 61000-4-6/EN 61000-4-6
ITU-T-K.20
IEC 61000-3-2/EN 61000-3-2
IEC 61000-3-3/EN 61000-3-3
ETSI EN 300 386 V1.2.1 (1998-11)
CE Statement (Europe)
This product complies with the European EMC Directive 89/336/EEC.
Regulatory Notices
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy; and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference to radio communications, in which case the user will be required to correct the
interference at their own expense.
© JBM Electronics Co. 1-800-489-7781 www.jbmelectronics.com