JVC SP-UXV100 - Manual (Page 12)

8
Using the Tuner
FM mode indicators
OR
■ Preset Tuning using the Remote Control (Possible
only after presetting stations)
Select the desired preset number using the UP, DOWN, > or <
button on the Remote Control. After 1 second the display will
show the preset number’s band and frequency.
Example: Press the UP button until the preset number 12
“P-12” appears.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM (MW/LW)
stations using the Remote Control.
Note: Preset numbers may have been set to factory test
frequencies prior to shipment. This is not a malfunction.
You can preset the stations you want into memory by
following one of the presetting methods below.
Presetting stations manually ––––––––
1 Select a band by pressing the FM/AM
button.
2 Press the 4 or ¢ button to tune in a
station.
3 Press the SET button.
“SET” will flash for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in Step 2 after
5 seconds, press the SET button again.
When the System is in use, the display shows other items as well.
For simplicity, only the items described in this section are shown here.
DOWN UP
(After 1 second)
Band display, Frequency
display, Preset channel
AUTO PRESET
FM/AM
¢ 4
DOWN
SET
DOWN UP MULTI CONTROL
TAPE FM/AM CD
STANDBY
PHONES
AUX
REC
REV MODE
AHB
PRO
TIMER
CLOCK
VOLUME
CD OPEN/CLOSE
FM/AM
¢
4
You can listen to FM and AM (MW/LW) stations. Stations can be
tuned in manually, automatically, or from preset memory storage.
■ Before listening to the radio:
• Make sure that both the FM and AM (MW/LW) antennas
are correctly connected. (See page 3.)
One touch radio ––––––––––––––––––––––
Just press the FM/AM button to turn on the System and start
playing the station you were last tuned to.
■ You can switch from any other sound source to the radio by
pressing the FM/AM button.
Tuning In a Station
1 Press the FM/AM button.
The band and frequency you were last tuned to appear on the
display.
(If the last station was selected using the preset number, the
preset number appears first.)
Each time you press the button, the band alternates between
FM and AM (MW/LW).
2 Select a station using one of the
following methods.
■ Manual Tuning
Press the 4 or ¢ button repeatedly to move from
frequency to frequency until you find the station you want.
OR
■ Auto Tuning
If you press and hold the 4 or ¢ button for one second or
more, the frequency changes down, or up, automatically until a
station is found.
REMOTE CONTROL RM-SUXV10E
CANCEL TREBLE
FM/AM
FM
MODE DISPLAY SLEEP
AUX TAPE CD
CD
BASS
AHB
PRO
DOWN RANDOM
UP
AUTO
PRESET
REPEAT
SET PROGRAM
VOLUME
UP
MONO STEREO
(On the Remote Control)
AM FM
FM/AM
FM/AM
AM FM
(On the Unit)
or
SET
FM = 30, AM = 15
STORED
When changing the Band
FM/AM SET SET
DOWN
UP
(Within 5 seconds)
or
< >
FM MODE
EN01-09.UX-V100[B]f 12/12/00, 12:34 PM 8