JVC SP-UXV100 - Manual (Page 7)

3
CAUTION: Make all connections before plugging the System into an AC power outlet.
Connecting the FM Antenna
AM EXT
AM LOOP
FM (75 Ω )
COAXIAL
ANTENNA
Turn the loop until you have the best reception.
CAUTION:
To avoid noise, keep antennas away from the
System, the connecting cord and the AC power
cord.
Connecting the AM (MW/LW) Antenna
R L
R
L
SPEAKERS
IMPEDANCE
MIN 4
Ω
AC IN
AM Loop Antenna (supplied)
Attach the AM loop to its base by snapping the tabs on the loop
into the slot in the base.
Using the supplied Wire Antenna
Using the coaxial type connector
(not supplied)
A 75
Ω
antenna with coaxial type connector (IEC or DIN 45325)
should be connected to the FM (75
Ω
) COAXIAL terminal.
If reception is poor, connect the outdoor antenna.
Note: Before attaching a 75
Ω
coaxial lead (the kind with a
round wire going to an outdoor antenna), disconnect the
supplied FM Wire Antenna.
FM Wire Antenna
(supplied)
R L
R
L
SPEAKERS
IMPEDANCE
MIN 4
Ω
AC IN
Coaxial cable
FM outdoor antenna
(not supplied)
Rear Panel of the Unit
Rear Panel of the Unit
EN01-09.UX-V100[B]f 12/12/00, 12:34 PM 3