JVC CA-MXJ200 - Manual (Page 14)

– 9 –
English
CAUTION:
SPEAKER IMPEDANCE
6
~ 16 OHMS.
SPEAKERS
RIGHT LEFT
2 3 1
AM (MW/LW) antenna Connecting Speakers
You can connect a pair of the front speakers.
Right
speaker
Left
speaker
Black
Red
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Speaker
cord
Speaker
cord
1 Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
2 Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
(MW/LW) loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop
antenna (supplied)
2 3 1
ANTENNA
AM LOOP
FM 75
COAXIAL
GND
AM
EXT
CA-MXJ300/J200[E] 01-14EN/f 00.4.7, 5:51 PM 9