JVC CA-MXJ200 - Manual (Page 25)

– 20 –
English
Recording
Recording Tapes on Deck B
1
Press EJECT
0 for the deck B.
2
Put in a recordable cassette, with the exposed
part of the tape down.
3
Close the cassette holder gently.
4
Check the tape direction of deck B.
• If the tape direction is not correct, press TAPE 2 3
twice then
7 to change the tape direction.
• If you want to record on both sides of a tape, press
REVERSE MODE until the indicator is lit.
5
Start playing the source — FM, AM*, CD
player, deck A, or auxiliary equipment
connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 21).
• When the source is deck A, you can also use the
dubbing method. (See “Dubbing Tapes” on page 21.)
* See “To record an AM (MW/LW) station – Beat Cut” on page
21.
6
Start recording.
On the unit:
Press REC START/STOP.
The indicator lights up on the display and
recording starts.
On the remote control:
1) Press REC PAUSE.
The indicator starts flashing on
the display.
2) Press TAPE 2 or TAPE 3.
The indicator stops flashing and
remains lit, and recording starts.
To stop during recording, press REC START/STOP again,
or press
7.
2 3
TAPE
REC
START/STOP
IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyrighted owner.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME control. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• While recording, you can hear sound modes and/or the
active bass extension effect through the speakers or
headphones. However, the sound is recorded without these
effects (see page 13).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can use type I and II tapes for recording.
To protect your recording
Cassettes have two small tabs on the back to protect
unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
When using type II tape, be careful not to cover the holes
used to detect the tape type.
0 EJECT
0 EJECT
Continued
Type II detection
slot
Adhesive tape
REC PAUSE
CA-MXJ300/J200[E] 20-28 EN/f 00.4.7, 5:54 PM 20