JVC CA-MXDVA9R - Manual (Page 15)

– 12 –
Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM.
(See pages 15 – 17.)
To playback discs, press DVD
3¥8 (or DVD 3 on the
remote control). (See pages 18 – 30.)
To playback tapes, press TAPE
2 3. (See page 31.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source
(FM/AM, DVD
3/8 (or DVD 3 on the remote control),
TAPE 2 3, and AUX), the unit turns on (and the unit starts
playing the source if it is ready).
Adjusting the Front Speaker Output Balance
If the sounds you hear from the front right and left speakers
are unequal, you can adjust the speaker output balance.
On the remote control ONLY:
1
Press LEVEL SELECT until “L”
and “R” appear on the display.
Initially the front speakers output balance is set
to the center.
2
Press LEVEL + or – to adjust the
front speaker output balance.
• Press LEVEL + to increase the right channel
output.
• Press LEVEL – to increase the left channel
output.
Continued
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on. The volume level can be adjusted in 32 steps (VOL MIN,
VOL 01—VOL 30, and VOL MAX).
Turn VOLUME + / – clockwise (+) to
increase the volume or
counterclockwise (–) to decrease it.
When using the remote control, press
VOL + to increase the volume or press VOL – to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source next time.
REMEMBER you cannot adjust the volume level
while the unit is off (on standby).
To turn down the volume level temporarily
Press FADE MUTING on the remote control.
The volume level gradually decreases to
“VOL MIN.”
To restore the sound, press the button again.
Setting the AM Tuner Interval Spacing
Only for CA-MXDVA9 except Australia:
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
• When shipped, the unit is set to 10 kHz interval.
On the unit ONLY:
You can only change the AM tuner interval
spacing while tuning into an AM station.
(See page 15.)
Press STANDBY/ON while holding
down
7.
• Each time you press these buttons, the
AM tuner interval spacing alternates
between 9 kHz and 10 kHz.
STANDBY/ON
STANDBY
EN11-17.CA-MXDVA9&9R[A,B,UJ]_1 01.8.6, 7:43 PM 12