JVC 0305TNH-II-IM - Manual (Page 18)

18
JVC’s AV CompuLink feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC brand VCR or DVD into your JVC DVD player and
the device will automatically turn on and begin playback. At the same time, using the
AV CompuLink, the VCR or DVD player sends a signal to the television telling it to turn on
and switch to the proper video input.
• The AV CompuLink cable may be included with the JVC AV CompuLink unit you
wish to connect. If it is not, contact JVC Parts Department at (800)-882-2345, or
www.jvcservice.com for part # EWP 805-012.
• AV CompuLink can only be used with JVC brand products.
Notes:
• In order for the VCR playback to begin automatically, the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR’s P
LAY button.
• If your JVC brand VCR has “A code/B code remote control switching” (see your VCR’s
instruction book), using VCR A code will switch the TV to input 1.
• Refer to your DVD instruction book for detailed connection information.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the receiver connection instructions for detailed connection information.
• AV CompuLink is compatible with select AV CompuLink receivers.
TV Underneath Panel
AV CompuLink
IN
OUT
V L R
IN
OUT
VCR
VIDEO
DIGITAL
AUDIO
DIGITAL
HDMI
AV COMPULINK
Connecting to JVC AV Compu Link
Quick Setup Connections
AV CompuLink Cable
To Connect: Plug one end of the AV compu link cable
into the AV COMPU LINK INPUT on your VCR, DVD, or
other compu link device. Plug the other end of the AV
compu link cable into the AV COMPU LINK underneath
the TV.
Note:
• The AV compu link cable has a male 3.5 mm (mono)
plug on each end.
PD-42X776 Eng1 18 3/24/05, 9:35:05 AM