JVC 0305TNH-II-IM - Manual (Page 53)

53
Power indicator allows you to adjust the brightness of
the power indicator
Press the M ENU button
π† To POWER INDICATOR
è To adjust POWER INDICATOR LOW, HIGH
or OFF
Note:
• If you set a timer on the TV, the power indicator will light even if the TV is on stand by.
Power Indicator
INITIAL SETUP
SELECT OPERATE EXIT MENU
NEXT PAGE
PREVIOUS
(2/5)
ON
OFF
ON
NOISE MUTING
FRONT PANEL LOCK
V1 SMART INPUT
VIDEO INPUT LABEL
POSITION ADJUSTMENT
POWER INDICATOR LOW
Position adjustment allows you to adjust the position of the picture on the screen vertically
when the aspect is set to panorama, cinema, or full.
Press the M ENU button
π† To POSITION ADJUSTMENT
è To enter
π † √® To adjust the position
Press the M ENU button to finish
Notes:
• To reset the adjustment to the center, press the
O K button.
• When the arrow disappears, while you are adjusting the position, the position is at it’s
maximum limit.
• If you select regular size with aspect or Multi Screen, position adjustment option is not seen.
• When you change the screen size, perform the position adjustment again.
• Position adjustment allows you to adjust the screen position vertically and horizontally when
the aspect is set PANORAMA ZOOM or CINEMA ZOOM for 720p signals.
Position Adjustment
OPERATE RESET EXIT OK MENU
Initial Setup
INITIAL SETUP
SELECT OPERATE EXIT MENU
NEXT PAGE
PREVIOUS
(1/5)
VIDEO-1MONITOR OUT
TV SPEAKER
AUDIO OUT
DIGITAL-IN
DIGITAL-IN AUDIO
CENTER CH INPUT
OFF
ON
VARI
SIZE1
DIGITAL
OFF
This function allows you to set whether the signal, which comes from VIDEO-1 input terminal,
should be output from MONITOR OUT terminal. If you select it from MONITOR OUT, set it to
"ON".
Press the M ENU button
π† To VIDEO-1 MONITOR OUT
è To select ON or OFF
Press the M ENU button to finish
Video-1 Monitor Out
PD-42X776 Eng1 53 3/24/05, 9:35:21 AM