Erx-700 series, Removing the fan tray, Erx-700 series -12 – Juniper Networks ERX-1410 User Manual
Page 104: Removing the fan tray -12, Figure 7-7
CHAPTER 7
Maintaining the ERX System
7-12
ERX-700 Series
shows the location of the fan tray in the ERX-700 series.
Figure 7-7 Location of fan tray on the front of the ERX-700 series
Removing the Fan Tray
Caution: Do not use the fan tray handle to carry the fan tray assembly. Use the
handle only to pull the tray out of the chassis.
To remove the fan tray:
1
Using a Philips screwdriver, loosen the two captive screws located at
top and bottom of the fan tray.
Warning: Do not place your fingers near the fans when removing the fan tray. The
blades may still be moving.
2
Pull the fan tray halfway out of the shelf.
Warning: Slowly slide the fan tray out of the chassis. The tray has no stops to
prevent it from sliding all the way out.
3
Pull the tray out of the chassis.