Juniper Networks ERX-1410 - Manual (Page 40)

CHAPTER 2
Installing the ERX System 2-4
Figure 2-3 Removing an L-bracket
8 Depending on where you want to position the system, proceed to
Freestanding Installation or Rack-Mounted Installation , later in this
chapter.
Unpacking the ERX-700 Series
The ERX-700 series come boxed but not attached to a skid.
For your convenience, we recommend that you unpack the ERX system
in the location where you want to install it.
To unpack the ERX-700 series:
1
Open the carton from the top.
2
Remove the box of accessories that sits on top of the system.
3
Before you remove the unit from its carton, proceed to Freestanding
Installation or Rack-Mounted Installation , later in this chapter.
Shipping
skid
Hex bolts
L-brackets