Juniper Networks ERX-1410 - Manual (Page 51)

Protecting Modules and Slots
ERX Edge Routers
3-5
On the ERX-1400 series, the grounding jacks are inside the front bezel in
the lower-left area of the front of the chassis (
Figure 3-4 ) and in the
upper-right corner on the rear of the chassis. On the ERX-700 series, the
grounding jack is in the lower-right corner on the rear of the chassis.
Caution: Always handle the module by its edges. Do not touch the components,
pins, leads, or solder connections.
Caution: Be sure to cover every empty slot with a blank faceplate to protect the
system from dust or other foreign substances and to ensure proper system cooling.
Figure 3-4 Connecting the wrist strap to the ERX-1400 series (front)
Order of Installation
Before you attempt to install or replace a module (inserted in the front of
the chassis), the corresponding I/O module (inserted in the rear of the
chassis) should already be in place. The system diagnostics run when a
module is installed in a chassis slot. If the corresponding I/O module is
not present, the diagnostics fail, and you need to remove and reinsert the
module.
CT3 CT3
ESD grounding jack Anti-static wrist strap