JDS Uniphase WEB XPANDER RS-232 - Manual (Page 15)

Appendix A – Web Xpander Commands
Command Description Example
:reset= Resets the Web Xpander :reset=
:factory= Load factory default
values (follow with
:reset= to restart
with these values)
:factory=
(then optionally) :reset=
:ipaddr= Sets the IP Address :ipaddr=192.168.0.20
:ipmask= Sets the Netmask :ipmask=255.255.255.0
:ipgate= Sets the Gateway Addr. :ipgate=192.168.0.1
:dns= Sets the DNS Address :dns=192.168.0.1
:dhcp= Enabled/Disables DHCP :dhcp=1
:smtp= Sets the outgoing
(SMTP) mail server :smtp=smtp.comcast.net
:user= Sets the user name
required for access :user=myname
:pass= Sets the password
required for access :pass=mypass
:webport= Sets the port (default =
80) for the web server :webport=80
:telnet= Sets the port (default =
23) for
telnet (Ethernet to
Serial) :telnet=23
:time= Sets the internet Time
server for time
synchronization :time=time-b.nist.gov
:daily= Sets the daily time sync
in number of minutes
from midnight :daily=210
(i.e. 3:30am)
:netinfo= Displays network
settings :netinfo=
:mailto= Sets a email recipient –
Can be sent up to 5
times per message to
indicate up to 5
recipients :[email protected]
:[email protected]
:mailfrom= Sets the email sender :[email protected]
:mailsubject= Sets the email subject :mailsubject=Test Email
:mailbody= Sets one or more lines of
email text.
This command can be
sent multiple times up to
500 characters total. :mailbody=Motion Sensor 1
Activated
:mailsend= Sends the email :mailsend=