JDS Uniphase WEB XPANDER RS-232 - Manual (Page 24)

Firmware Utility Communications Options
6. From the main menu, select File, Load Flash Image
7. Click the button next to File Location and locate the firmware you
downloaded from the JDS Technologies web site.
8. Click the “OK” button to begin the transfer. Do not do anything else
with your computer or switch to another window until the transfer is
complete.
9. When the transfer is complete, carefully remove the programming cable
from the Web Xpander and press the Reset button located above the
battery. The green Link light should go off briefly and then turn on again
during the reset.
Transferring Web Pages to the Web Xpander
Depending on the firmware version, one or more web pages might need to be transferred
from your PC into the Web Xpander’s memory. This transfer is accomplished with the
latest Web Xpander Labeler application.
1. Start the Web Xpander Labeler application located on the Start Menu in the Web
Xpander folder (labeled WebX Labeler).
2. Display the configuration information by selecting Options, Configuration from
the main menu if this information is not currently displayed.
3. Verify the correct settings for your installation. Web Page transfer as well as
label updates always occur over the network.
4. Click “Test Connection” to verify network connectivity between your PC and the
Web Xpander. (You should have already verified that you can view the web
pages from your browser)