JA Audio 9902S - Manual (Page 32)

GB 32
The Normal recording
When you want to perform what we call a Normal recording.
• Press on the remote control to pick up the recording menu.
• Step down to “ ” in the menu.
• Start the recording by pressing OK.
• The display on the box will show “r E C” during this type of
recording.
• If you press the green button on the remote control while a
recording is in progress you can preset the recording time. This
is called OTR (one touch recording). There are preset times in
30 minute steps up to 240 minutes. Each time you press the
green button you will add 30 minutes to the recording time.
When the preset recording time is reached, the recording will
stop automatically. The display on the box will show “r XXX”
during this type of recording. XXX is the time you have set for
the recording.
• During the recording, elapsed time and the information “Re-
cording” will be shown in the recording menu. If you have
used the OTR function described above, you will also see how
much time that is left until the recording stops.
• Finish the recording by first pressing to call up the record-
ing menu. (If it is already on the screen, you do not have to
press
first!)
Then check that “ ” is highlighted in the menu (if not, se-
lect it) and then press OK.
Timer recording
The “ ” alternative in the recording menu is a short cut to the
“Timer” menu. From there you can program the box to perform
recordings when you are not at home.
Please refer to the “Timer setup” described on page 56.
For your information, in case you are at home watching TV when
a timer recording starts:
Shortly before a timer recording starts, the message in the right
figure will be shown. Press OK if you want the recording to take
place; press BACK if not. (You will be asked just in case you are
watching a more interesting programme than the one that is to
be recorded.)
When you do nothing the recording will start in a moment.
HARD DISK RECORDING