JA Audio 9902S - Manual (Page 57)

GB 57
MAIN MENU
Indicates a recording event
Important information related to the timer recording
If you program the box to perform a timer recording e.g. in the
middle of the night (or at any other unsuitable time), be sure to
turn the TV set off with the mechanical switch located on the TV!
If you turn the TV set off by just putting it into standby mode with
the remote controll, it will be turned on at the time for the record-
ing!
Timer setup
• Select Timer from the Main Menu.
• Press OK to enter the Timer Setup menu from where you
make the settings.
• First, select Channel List with the buttons.
• Then, step to Channel to select desired TV/Radio channel.
• The present date (month/day) will automatically be preset.
When you change month and day, always use two digits for
each of them.
• If you enter a wrong digit you can erase it with the button.
The different start times may never overlap each other. If you try
to enter a start or stop time within an already occupied period of
time you will get a warning message about it.
• On the last line you select the Action. When you want an
event to be recorded on the built in hard disk at the date and
time you entered, select Record. Events that you want to be
recorded this way will be marked with a red symbol in the
Timer list.
Do not forget to ensure that you have enough space on the
disk at the time for the recording to take place.
• If you just want to be reminded of a programme start,or when
you want to make a traditional analogue (VCR) recording, se-
lect View.
Up to 9 different events can be predefined. The events will be
sorted in start time order.
At each stop time the box will return to the state it had before it
started.
You can erase a predefined event by pressing the button twice.
(If you regret the command after the first press, go to another line
by pressing either or and the event will not be erased.)