JVC GET0075-001A - Manual (Page 43)

ENGLISH
43
To change the display information while
tuning in to an ensemble
Normally service name is shown on the display.
If you want to change the display information, press
DISP (D).
Each time you press the button, the
following information appears on the
display for a while.
To tune in to a particular ensemble without
searching:
1 Press and hold DAB (FM/AM) to select DAB
tuner as the source.
2 Press DAB (FM/AM) repeatedly to select the
DAB band (DAB1, DAB2 or DAB3).
3 Press and hold ¢ or 4 for more
than 1 second.
4 Press ¢ or 4 repeatedly until the
ensemble you want is reached.
• If you hold down the button, the frequency
keeps changing until you release the button.
To restore the FM/AM tuner
Press and hold DAB (FM/AM) again.
3
Start searching an ensemble.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
Press ¢ to
search ensembles
of higher
frequencies.
Press 4 to
search ensembles
of lower
frequencies.
Press 5 (up) to select
the next service.
Press ∞ (down) to
select the previous
service.
Ensemble name
Service name
Channel number
Frequency
EN42-45KD-LH7R_LH5R[E]f.pm5 1/18/02, 1:52 PM 43