JVC GET0075-001A - Manual (Page 44)

ENGLISH
44
Storing DAB services in
memory
You can preset up to 6 DAB services in each DAB
band (DAB1, DAB2 and DAB3) manually.
1
Select the DAB tuner.
Each time you press and
hold the button, the DAB
tuner and the FM/AM tuner
are alternately selected.
2
Select the DAB band (DAB1, DAB2 or
DAB3) you want.
Each time you press the
button, the DAB band
changes as follows:
3
Tune in to an ensemble you want.
4
Select a service of the ensemble you
want.
FM/AM DAB
5
Press and hold the number button
(in this example, 1) you want to
store the selected service into for
more than 2 seconds.
6
Repeat the above procedure to
store other DAB services into other
preset numbers.
Notes:
• A previously preset DAB service is erased when a
new DAB service is stored in the same preset number.
• Preset DAB services are erased when the power
supply to the memory circuit is interrupted (for
example, during battery replacement). If this occurs,
preset the DAB services again.
Selected band/preset number and
“MEMO” (memory) appear
alternately for a while.
(DAB 1) (DAB 2) (DAB 3)
D1 D2 D3
FM/AM DAB
Tuning in to a preset DAB
service
You can easily tune in to a preset DAB service.
Remember that you must store services first. If
you have not stored them yet, see the column
on the left.
1
Select the DAB tuner.
Each time you press and
hold the button, the DAB
tuner and the FM/AM
tuner are alternately
selected.
Press 5 (up) to select
the next service.
Press ∞ (down) to
select the previous
service.
EN42-45KD-LH7R_LH5R[E]f.pm5 1/18/02, 1:52 PM 44