Johnson Controls SA PD 180 THRU 240 - Manual (Page 3)

430645-YIM-D-0610
Johnson Controls Unitary Products 3
Safety Considerations
Installer should pay particular attention to the words: NOTE,
CAUTION, and WARNING. Notes are intended to clarify or
make the installation easier. Cautions are given to prevent
equipment damage. Warnings are given to alert installer that
personal injury and/or equipment damage may result if
installation procedure is not handled properly.
Reference
This instruction covers the installation and operation of the
basic condensing unit. For refrigerant piping installation
instructions refer to document 247077 “Application Data -
General Piping Recommendations for Split System Air
Conditioning and Heat Pumps”. For information on the
installation and operation of the evaporator blower units, refer
to Instruction Manual No. 508526.
All accessories come with a separate Installation Manual.
Renewal Parts
Contact your local Source 1 Center for authorized replacement
parts.
Agency Approvals
Design certified by CSA as follows:
1. For use as a cooling/heating unit.
2. For outdoor installation only.
Inspection
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier’s freight bill. A separate
request for inspection by the carrier’s agent should be made in
writing.
Improper installation may create a condition where the
operation of the product could cause personal injury or
property damage. Improper installation, adjustment,
alteration, service or maintenance can cause injury or
property damage. Refer to this manual for assistance or
for additional information, consult a qualified contractor,
installer or service agency.
Before performing service or maintenance operations on
unit, turn off main power switch to unit. Electrical shock
could cause personal injury. Improper installation,
adjustment, alteration, service or maintenance can
cause injury or property damage. Refer to this manual.
For assistance or additional information consult a
qualified installer, service agency or the gas supplier.
This system uses R-410A Refrigerant which operates at
higher pressures than R-22. No other refrigerant may be
used in this system. Gage sets, hoses, refrigerant
containers and recovery systems must be designed to
handle R-410A. If you are unsure, consult the
equipment manufacturer. Failure to use R-410A
compatible servicing equipment may result in property
damage or injury.
This product must be installed in strict compliance with
the enclosed installation instructions and any applicable
local, state and national codes including, but not limited
to, building, electrical, and mechanical codes.