John Lewis JLWM1402 1400 - Manual (Page 8)

8
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the Start/Pause button, the
countdown begins, and the delay time value decreases
by one unit every hour up to 2 hours and then by 30
minutes.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter).
8 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried out
will remain lit.
E20
When you PAUSE the cycle, and it becomes possible to
open the door, provided:
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
If all these requirements are met, the door locked light
goes off.
Important! You must set the washing machine to
Pause before you make any change in the programme
in progress.
7 Display
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washing machine has completed the
programme: this is indicated by a flashing zero.
• The washing machine has stopped with water in
the tub, at the end of the “Soak 30°” or a
programme with the “Quiet” option: this is indicated
by a flashing zero.
0
2.05