Jeep HOT WHEELS N9356 - Manual (Page 11)

ASSEMBLY
13
• Fit the tabs on the hood into the slots in front of the windshield .
• Lower the hood .
14
Hood
Slots
• Fit the tabs on the bottom of the grille into the slots on the front
of the vehicle .
• Press near the top of the grille to fit into place .
Grille
15
• Turn the vehicle on its side .
• Fit a traction band around a wheel .
• Slide a slotted screwdriver under the traction band to push the
traction band onto the ridge in the center of the wheel .
Hint: If the traction band is difficult to fit around the wheel, you
may want to soak it in warm water to soften it slightly.
• Repeat this procedure to assemble a traction band to each wheel .
• Turn the vehicle upright .
Traction
Band
Wheel
Ridge
BOTTOM VIEW
• “Snap” the ends of the spark plug wires set into the holes on
the battery retainer (engine cover) .
IMPORTANT! You must install your Power Wheels ® battery in
your vehicle before assembling the battery retainer under the hood .
Please refer to "Battery Installation" on page 13 for detailed instructions .
16
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Battery Retainer
(Engine Cover)
11
N9356pr-0920