Jeep HOT WHEELS N9356 - Manual (Page 7)

1
Charger Connector
2
BATTERY CHARGING
Battery Connector
• Plug the battery connector into the charger connector .
IMPORTANT! If you are recharging your battery, you will first
need to lift the hood and remove the battery retainer (pretend
engine cover) . Disconnect the battery connector from the motor
harness connector .
• Plug the charger into a standard wall outlet .
Note: Use the charger only in a wall outlet . Do not plug the charger
into a ceiling outlet . If power flow to the wall outlet is controlled
by a switch, make sure the switch is ON . The power indicator on
the charger does not indicate the charge status of your battery .
The power indicator allows you to see that there is power from the
wall outlet .
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours .
• Recharge the battery for at least 14 hours after each use of your
vehicle . Do not charge the battery longer than 30 hours .
• Once the battery is charged, disconnect the charger connector
from the battery connector . Unplug the charger from the wall
outlet . The battery is now ready to be installed in your vehicle .
Please see the Battery Installation section on page 13 for detailed
instructions on installing your battery .
Battery Connector

N9356pr-0920