JVC DR-MV5BEK - Manual (Page 80)

Filename [MV5SEK_13Subsidiary.fm]
Masterpage:Left+
80
EN
SUBSIDIARY SETTINGS
Page 80Wednesday, 31 August 2005 19:58
OTHERS
8 RESUME — OFF / ON / DISC RESUME
When this function is set to “ON” or “DISC RESUME”, you can use
the resume function. (
੬ pg. 48)
OFF : You cannot use the resume function.
ON : You can start playback from the resume point of the placed
disc.
DISC RESUME : The unit retains a memory of the resume points of
the last 30 discs played back, even though they have been
ejected.
NOTE:
“DISC RESUME” setting works on DVD VIDEO, VCD and already
finalised DVD-R/DVD-RW (video mode) discs. For other types of discs,
the function under “ON” setting will be applied even if “RESUME” is set
to “DISC RESUME”.
8 AUTO POWER OFF — OFF / 3H
When this function is set to “3H”, the unit is turned off automatically
if no operation is done with 3 hours.
If you connect the unit and TV with Component Video Connection
(
੬ pg. 15), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction
of higher-quality images.
8 Interlaced scan
In the conventional video system, a picture is shown on the display
monitor in two halves. The Interlaced scan system places lines of
the second half of the picture in-between lines of the first half of the
picture.
8 Progressive scan
Progressive scan displays all the horizontal lines of a picture at
one time, as a single frame. This system can convert the interlaced
video from DVD into progressive format for connection to a
progressive display. It dramatically increases the vertical
resolution.
1
Press DVD so that the DVD lamp lights up on the unit.
2
Press PROGRESSIVE SCAN for 3 or more seconds.
● Video output indicator ( ) lights on the front display panel if
Progressive scan mode has been established. (
੬ pg. 14)
● Each press of PROGRESSIVE SCAN for 3 or more seconds
switches the scan mode.
NOTES:
● When the progressive mode is set, be sure to set “L-1 OUTPUT” to
“COMPONENT”. ( ੬ pg. 44) Progressive scan is output only from
[COMPONENT VIDEO OUT] connector.
● Interlaced scan mode is the setting at your purchase.
● Interlaced scan mode might be suitable depending on video material.
● Scan mode cannot be set while menu screen is displayed.
● When the Progressive scan mode is engaged, no video signal is
output from [L-1 IN/OUT] connector.
Scan Mode Set
ATTENTION:
● Your TV needs to be compatible with Progressive.
● Make sure that there is no disc in the unit.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
Watch the images on VHS deck in the Progressive scan
mode via component video
1
Set the Progressive-compatible TV to the component input
mode.
2
Press DVD so that the DVD lamp lights up on the unit.
3
Press PROGRESSIVE SCAN for 3 or more seconds.
● The video output indicator lights up on the front display panel.
4
Press VHS so that the VHS lamp lights up on the unit, then
press PROGRESSIVE SCAN.
● “]” lights up on the unit.
NOTES:
● Be sure to engage the DVD deck in stop mode.
● During still picture in VHS Progressive Scan mode, the images
may jitter, but this is not a malfunction.
DVD
VHS
PROGRESSIVE
SCAN
MV5SEK_00.book Page 80 Wednesday, August 31, 2005 7:58 PM