Configuring a custom display message – Juniper Networks EX4200 User Manual
Page 193
To re-enable the Maintenance menu in the LCD panel on EX8200 switches:
[edit]
user@switch# set chassis lcd maintenance-menu enable
Configuring a Custom Display Message
You can configure the second line of the LCD to display a custom message temporarily
for 5 minutes or permanently.
To display a custom message temporarily:
■
On an EX3200 switch, a standalone EX4200 switch, or an EX8200 switch:
user@switch> set chassis display message message
■
On an EX4200 switch in a Virtual Chassis configuration:
user@switch> set chassis display message message fpc-slot slot-number
where
slot-number
is the member ID of the member switch.
To display a custom message permanently:
■
On an EX3200 switch, a standalone EX4200 switch, or an EX8200 switch:
user@switch> set chassis display message message permanent
■
On an EX4200 switch in a Virtual Chassis configuration:
user@switch> set chassis display message message fpc-slot slot-number
permanent
where
slot-number
is the member ID of the member switch.
NOTE: The
Menu
button and the
Enter
button are disabled if the LCD is configured
to display a custom message.
To disable the display of the custom message:
user@switch> clear chassis display message
Related Topics
LCD Panel in EX3200 and EX4200 Switches on page 13
■
■
LCD Panel in an EX8200 Switch
Configuring a Custom Display Message
■
167
Chapter 12: Performing Initial Configuration