Juniper Networks EX4200 - Manual (Page 209)

4. Note the member ID displayed on the front panel.
5. Issue the request virtual-chassis renumber command from the Virtual Chassis
master to change the member switch’s current member ID to the member ID
that belonged to the member switch that was removed from the Virtual Chassis
configuration).
Remove a Member Switch and Make Its Member ID Available for Reassignment to a
Different Switch
When you remove a member switch from the Virtual Chassis configuration, the
master keeps its member ID on reserve. To make that member switch’s member ID
available for reassignment, issue the request virtual-chassis recycle command from
the Virtual Chassis master.
NOTE: When you add or delete members in a Virtual Chassis configuration, internal
routing changes might cause temporary traffic loss for a few seconds.
Related Topics ■ Monitoring Virtual Chassis Configuration Status and Statistics
■ Adding a New Switch to an Existing Virtual Chassis Configuration (CLI Procedure)
on page 105
Remove a Member Switch and Make Its Member ID Available for Reassignment to a Different Switch ■ 183
Chapter 13: Removing Switch Components