Juniper Networks EX4200 - Manual (Page 69)

Optical Interface Support in EX3200 and EX4200 Switches
Optional uplink modules for EX3200 and EX4200 switches support SFP, SFP+, or
XFP transceivers. This topic describes the optical interfaces supported for those
transceivers. It also lists the copper interface supported for the SFP transceivers.
NOTE: Use only optical transceivers and optical connectors purchased from Juniper
Networks for your EX Series switch.
The Gigabit Ethernet SFP, SFP+, or XFP transceivers installed in EX3200 or EX4200
switches support digital optical monitoring (DOM): you can view the diagnostic details
for these transceivers by issuing the operational mode CLI command
show interfaces
diagnostics optics . The command does not give any output for copper transceivers,
Fast Ethernet transceivers, or transceivers not purchased from Juniper Networks.
The four tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables for SFP, SFP+, and XFP
transceivers and over the copper interface for SFP transceivers:
■ Table 18 on page 44—Optical interface support and copper interface support
for Gigabit Ethernet SFP transceivers.
■ Table 19 on page 55—Optical interface support for Fast Ethernet SFP transceivers.
■ Table 20 on page 61—Optical interface support for Gigabit Ethernet SFP+
transceivers.
■ Table 21 on page 64—Optical interface support for Gigabit Ethernet XFP
transceivers.
Optical Interface Support in EX3200 and EX4200 Switches ■ 43
Chapter 3: Component Specifications