JVC CA-HXZ30 - Manual (Page 30)

25
English
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
CLOCK
/TIMER
SET
/DISPLAY
PRESET
T U N IN
G
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically.
• You can set the timers whether the unit is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified
station, sets the volume level to “VOLUME MIN,” and starts
recording when the on-time comes. (“REC” and the REC
indicator on the display flash just before the on-time. The
REC indicator continues flashing while the timer is
operating). Then, when the off-time comes (“REC OFF”
appears on the display just before the off-time), the unit
automatically turns off (standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
• To correct a mistake while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1
Insert a recordable cassette with the exposed
part of the tape down.
2
Press CLOCK/TIMER repeatedly
until “REC” appears on the display.
The (Timer) indicator lights up and the REC
(Recording Timer) indicator also starts flashing
on the display.
• Each time you press the button, the timer setting modes
change as follows:
3
Press CLOCK/TIMER again.
“TIMER” appears for about 2 seconds, then
the unit enters on-time setting mode.
4
Set the on-time you want the unit to turn on
at.
1) Turn ¢ / 4 to set the hour,
then press SET/DISPLAY.
2) Turn
¢ / 4 to set the minute,
then press SET/DISPLAY.
“SET” appears for about 1
second, then the unit enters off-
time setting mode.
5
Set the off-time you want the unit to turn off
(standby) at.
1) Turn ¢ / 4 to set the hour, then press
SET/DISPLAY.
2) Turn ¢ / 4 to set the minute, then press
SET/DISPLAY.
“SET” appears for about 1 second, then the unit enters
preset station selecting mode.
6
Select the preset station.
1) Turn ¢ / 4 to select the band (“TUNER FM” or
“TUNER AM”), then press SET/DISPLAY.
“SET” appears for about 1 second.
2) Turn ¢ / 4 to select a preset channel number,
then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
and remains lit. “OK ” appears on the display for
about 2 seconds.
The settings you have done are shown on the display
in sequence for your confirmation.
7
Press to turn off the unit
(standby) if necessary.
• If you want to listen to another source while recording
Press REC START/STOP or 7 to stop recording. Without
stopping it, you cannot change the source.
• Even if you unplug the AC power cord or if a power failure
occurs
Once you set the timer, the timer setting may remain stored in
memory for a few days. Check whether or not the timer setting
still remains.
STANDBY
CLOCK
/TIMER
EN21-26.HX-Z10&30[UW&UJ]1 03.3.6, 5:25 PM 25