JVC MX-C55 - Manual (Page 23)

20
Playing Back from the External Source
Connecting to Your PC
This system is equipped with a USB terminal on the front
panel. You can connect your PC to this terminal and enjoy
sound reproduced through your PC.
When you connect your PC for the first time, follow the
procedures below.
• The system cannot send any signal or data to your PC.
IMPORTANT
Always set volume to VOL MIN when connecting or
disconnecting the other equipment.
5
Check if the drivers are correctly installed.
1 Open the Control Panel on your PC: Select [Start]
=
[Settings]
= [Control Panel]
2 Click [System] = [Hardware] = [Device Manager] =
[Sound, video and game controllers] and [Universal
Serial Bus controllers]
• The following window appears, and you can check
whether the drivers are installed.
* The installed drivers are shown only when the unit is
connected to the PC.
To playback sounds stored on the PC
Refer the manuals supplied with the sound reproduction
application installed in the PC.
• Noise and static electricity may stop the sound through the
USB connection. In this case, do the following operations:
– Disconnect and connect the USB cable again.
– Restart the music software on your PC.
– Turn off and on the unit.
• Windows ® 98SE, Windows Me, Windows 2000 and
Windows XP are registered trademarks of Microsoft
Corporation.
DO NOT turn off the unit and disconnect the USB
cable while installing drivers and playing back, and
for several seconds after your PC recognizes the
unit.
How to install the USB drivers
The following procedures are described using the Microsoft
Windows
® XP. If your PC is running on a different version of
Windows, the screen shown on your PC’s monitor will differ
from the ones described in the following procedures.
1
Turn on your PC, and close all the running
applications.
2
Turn on the unit and press USB/
AUX repeatedly to select USB.
3
Connect the unit to the PC using a USB cable
(not supplied).
• Use “USB series A plug to B plug” cable when
connecting.
4
The USB drivers are installed automatically.
• If the USB drivers are not installed automatically, install
the USB drivers manually following the instructions
displayed on the PC’s monitor.
USB/AUX
(this unit)
Continued
MXC55[J]B_18-21.p65 2/16/06, 2:46 PM 20