Samsung SV-5000 - Manual (Page 18)

14
GB
Connecting Your VCR to the TV
To receive television programs from an over-the-air or cable
television network, a signal must be received from one of the
following sources.
◆ An outdoor antenna.
◆ An indoor antenna.
◆ A cable television system.
☛
Make sure that both the television and the VCR are
switched off before connecting the cables.
1 Remove the 75
Ω
coaxial cable from the television.
2 Connect this cable to the 75
Ω
coaxial socket marked on the
rear of your VCR.
3 Plug the coaxial cable supplied into the socket on your VCR.
4 Plug the other end of the coaxial cable into the connector
previously used for the antenna on the television.
5 Connect one end of the RCA cable supplied to the output
jacks(OUT1 or OUT2) on the rear of the VCR.
➢
Respect the color coding of the Audio and Video In/Out
cable.
6 Connect one end of the SCART cable to the EURO AV socket on
the rear of the VCR.
7 Plug the other end (of the RCA cable or SCART cable) into the
appropriate connector on the television.
◆ Regardless of the type of connection chosen, you must
always connect the coaxial cable supplied. Otherwise, no
picture will be visible on the screen when the VCR is
switched off.
* NOTICE:
Use the supplied RF adaptors as needed when making RF
connections.
[NTSC/PAL-M Region]
TV
TV
VIDEO
AV
TV
VIDEO N
AV
TV
VIDEO
OUT 2
R
L
AUDIO
OUT 1
R - AUDIO - L VIDEO
LINE 2 IN
EURO AV
TV
2
3
6
TV
VIDEO
OUT 2
R
L
AUDIO
OUT 1
R - AUDIO - L VIDEO
LINE 2 IN
EURO AV
5
SV-5000W/SECA1 4/1/1 12:15 AM Page 14