Smart Technologies SMART Meeting Pro 3.1 - Manual (Page 41)

Chapter 4: Configuring SMART Meeting Pro
software
Activating SMART Meeting Pro software after installation 35
Adding a unique e-mail address to each computer after installation 37
Orienting your SMART Board interactive whiteboards after installation 38
This chapter provides information on using the following procedures to configure SMART Meeting Pro
software after installation.
l
Activating SMART Meeting Pro software after installation
l
Adding a unique e-mail address to each computer
l
Orienting your SMART Board interactive whiteboards
Activating SMART Meeting Pro software after
installation
There are two situations in which the software doesn’t activate completely:
l
Imaging a computer: For the software to activate properly, each computer you install it on
must have a unique installation ID. If you use a computer image or clone a hard drive to set up
multiple computers, they all have the same installation ID as the original computer, which can
cause an activation error.
l
Protecting software for computer configurations: If you use system recovery or protection
software, you should activate the software before you lock or freeze the computer for your
users. However, if you can’t, you must activate the software afterward.
I M P O R T A N T
SMART Meeting Pro software and SMART Meeting Pro connector for Lync have separate product
keys. You must enter both product keys during the software installation process to use
SMART Meeting Pro software with Lync integration enabled.
Chapter 4
35