Sanyo SID-70 - Manual (Page 6)

COLOR DOME CAMERA User Guide 10 COLOR DOME CAMERA User Guide 11
An arrow for installing
directions
1) Separate the dome cover by turning anti-clockwise.
2) Separate the shield case by pulling from the camera body.
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Latch
Locking direction
[Figure1]
Locking direction
(Clockwise)
Main Body
(Camera)
Shield Case
Dome cover
Unlocking direction
(Anti-clockwise)
Installation
When using the Ceiling bracket
Installation
• The installation should be done by qualified
service personnel or system installers.
• If the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• To change the position of the cable, take
away the Hole Cover and pass the cable
through.
Notes
Original position of
the cable
Hole Cover
[Figure-2]
M4 tapping
screw
Pan Base
fixation
screw Unlocking
direction
M4 tapping
screw (provided)
Dome cover
CAMERA
Locking
direction
Ceiling bracket
1) Hold the ceiling bracket (located where the arrow
points to) and separate it from the main body of
the camera by rotating it anti-clockwise.
(refer to the picture in 'Notes' on page 10)
2) Place the separated ceiling bracket so that the
“Front” side faces the area to be monitored and
install it with the M4 tapping screws.
3) To combine the main body with the ceiling bracket,
make sure that the pan base fixation screw face the
opposite side of the “Front” side of the ceiling
bracket and rotate it clockwise.
4) Adjust the camera lens to face the area to be
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
• If you want to install the camera with the ceiling bracket combined, fix it using two M4 tapping
screws at the side of the main body (refer to the [Figure-2] on page 11).
Notes