SEAL 6500 User Manual

Page 17

Advertising
background image

S E T- U P A N D O P E R A T I O N

17

TEMPERATURE SETTINGS

• Select the film(s) that you will use on the top (and

bottom) of the images.

• Check which temperature setting is recommended for

your SEAL

®

Brands material (see literature enclosed in

your material box).

• Refer to the Control Panel diagrams for information

on setting the temperature.

NOTE: If a process requires heat, turn ON the heaters
approximately 45 minutes before use to ensure that the
rollers are at the correct operating temperature.

IMPORTANT! The main roller should be down and
turning to prevent uneven hot spots on the roller. A
stationary heated roller will develop concentrated heat
in one area, which will damage the roller.

SHIM WHEEL SETTINGS

Whenever you mount onto a board, etc., it is important
to adjust the rollers to create a gap nearly equal to the
thickness of the board being used. This is done so that
anything passing between the rollers will receive the right
amount of pressure.

Equivalent Press Measurements

Inches

Metric (mm)

Decimal

1

25 mm

1.000

3/4

19 mm

0.75

1/2

13 mm

0.50

3/8

10 mm

0.375

1/4

6 mm

0.25

3/16

5 mm

0.1825

1/8

3 mm

0.125

1/16

2 mm

0.0625

-1/16

-2 mm

-0.0625

0 0

0

HOW TO SET THE SHIM WHEELS

• First, determine the thickness of the board that you will

use for mounting.

• You must first raise the rollers and then turn the shim

wheels until the desired measurement corresponds with
the thickness of board being used.

WARNING! Too much pressure can crush the board
being used and even damage the top and bottom
rollers. Normally, a press of .025" (0.6mm) is
sufficient.

0

19

m

m

2

5 m

m

-2m m 2 mm

3 m

m

5

m

m

3

/4

in

1 in

-1/16 in 1/16 in

1

/8 in

3

/16

in

Figure 9. Shim Wheel Adjustment

Advertising