Siemens 4000 - Manual (Page 7)

7
Gigaset 4000 Classic, IM1 eng, A31008-G4000-B001-2-6Z19
4000Cla.fm 17.11.00
Attaching the belt clip
Push the belt clip onto the back of the handset until
the lugs at the side click into place.
Switching the handset on and off

To switch the handset on and off,
hold down the end call key until
you hear a confirmation beep (ris-
ing tone sequence).
Activating/deactivating the keypad lock
You can disable the handset keypad to protect the key-
pad against inadvertent use. If there is an incoming
call, the key lock is automatically deactivated and re-
activated after the call has ended.
4
To activate/deactivate, hold
down
key. You will hear a beep
(rising tone sequence).
Accepting a call: Press the talk key

.
● Once the initial charging process is completed you
can replace your handset into the base station/
charging unit after each call. Charging is controlled
electronically. This ensures optimum charging and
prolongs battery life.
● The batteries heat up during charging. This is nor-
mal and not dangerous.
● Opening the battery compartment unnecessarily
may cause the wrong charging status to be dis-
played.
The handset is switched on as soon as you insert the
batteries and place the handset in the base station/
charging unit.