Siemens 4000 - Manual (Page 9)

9
Gigaset 4000 Classic, IM1 eng, A31008-G4000-B001-2-6Z19
4000Cla.fm 17.11.00
Registering the handset
To make calls with your handset, you must “intro-
duce” it to its base station (registering)
● if your handset has already been registered at a dif-
ferent
base station (steps 1, 2 and 3),
● if you want to register the handset as a new hand-
set at a Gigaset base station of an older Gigaset
range
(steps 1 and 3).
Step 1: On the base station or base telephone
Step 2: On the handset:
MENU Open the menu.

REGISTER HS OK Select the menu item and con-
firm.
The PIN is displayed.
Step 3: On the handset:

OK Enter the 4-digit system PIN and
confirm.
Gigaset On the base station/base telephone
4010/4015 Hold down the key on the underside
of the base station.
3010/3015 Hold down the paging-key # of the
base station (for about 10 seconds) un-
til you hear signal tones.
3020/25
3030/35
4030/35 Select VHWWLQJV , V\VWHPVHWWLQJV
and UHJLVWHUKDQGVHW in the menu at
the base station telephone and con-
firm with
2. .
3070/75
4070/75 Press the LED – it will flash during
registration.
Non-Sie-
mens base
stations To register at “GAP base stations” , fol-
low the relevant operating instructions
(step 2 and 3).
Once you have entered the system PIN the handset
will search for a base station with this PIN. During the
search,
will flashes on the display. When
it has been registered successfully, the handset will
revert to its idle status. Your handset is now ready
for operation.
REGISTER HS