Sun Microsystems SUN FIRE X4640 - Manual (Page 45)

TABLE 1 SIA State File Variables (Continued)
Variable Description (Defaults in Bold)
Required for
Linux Install
Required
for
Firmware
Upgrade
apit.remoteUpdateURL If you specified “true” for remoteUpdate, tells SIA
where to look for SIA software updates. Values
supported: Any URL with updated SIA content files.
You only need to specify this variable if you are not
using the default url.
Default url:
http://sia-updates.sun.com/remoteUpdate
X (if
remote
Update is
true and
default url
is not
used) X (if
remote
Update
is true
and
default
url is not
used)
apit.networking Tells SIA it has permission to work over the network.
If true, SIA will configure network settings based on
networkconfig variables. Values supported: true |
false
Example: apit.networking=true
X X
apit.networkconfig.needNetwork If you specified “true” for network, tells SIA whether
network access is required for a particular task.
Values supported: true | false
Example: apit.networkconfig.needNetwork=true
X (if
networking
is true) X (if
networking
is true)
apit.networkconfig.activeNic If you specified “true” for network, tells SIA which
network interface is connected to the active network.
Values supported: eth0 | eth1 | eth2 | eth3 ... etc.
Example: apit.networkconfig.activeNic=eth0
X (if
networking
is true) X (if
networking
is true)
apit.networkconfig.NetworkType If you specified “true” for network, tells SIA the
configuration of the active network interface. Values
supported: static | dhcp
Example: apit.networkconfig.NetworkType=dhcp
X (if
networking
is true) X (if
networking
is true)
apit.networkconfig.useDHCP If you selected “dhcp” as the NetworkType, tells SIA
to obtain the server’s address from the DHCP server.
Values supported: true | false
Example: apit.networkconfig.useDHCP=true
X (if
networking
is true) X (if
networking
is true)
apit.networkconfig.ipfield If you selected “static” as the NetworkType, tells SIA
to use the server’s IP address value you provide.
Example: apit.networkconfig.ipfield=n.n.n.n
X (if static
IP is used) X (if
static IP
is used)
apit.networkconfig.gatewayField If you selected “static” as the NetworkType, tells SIA
to use the IP address value you provide.
Example: apit.networkconfig.gatewayfield=n.n.n.n
X (if static
IP is used) X (if
static IP
is used)
Contents of the SIA State File
45