Sun Microsystems SUN FIRE X4640 - Manual (Page 64)

▼
How to Get the Syslinux and SIA Software
Note – Support for creating a USB flash drive version of SIA was introduced with SIA version
2.0.144 and is provided as a downloadable package from the Sun download site. Earlier versions
of SIA will not support running SIA from USB flash drive media.
Go to the SIA main page on the Sun web site:
http://www.sun.com/systemmanagement/sia.jsp
Navigate to your server’s download page.
Select and download the following files to a convenient file folder on a Windows XP or Linux
(Red Hat or SUSE) system.
■ syslinux- version.zip (where version is 3.52 or later)
■ sia- version.zip (where version is 2.0.144 or later)
Note – These files may be available separately or bundled in a single package.
Preparing the USB Flash Drive
This section describes how to prepare the USB flash drive in order to use it to run the SIA
software on your server. You can use either a Windows or a Linux system to prepare the USB
flash drive. The procedure is different for Windows and Linux systems; both procedures are
described below.
■ “How to Prepare the USB Flash Drive on a Windows XP System” on page 64
■ “How to Prepare the USB Flash Drive on a Linux (Red Hat/SUSE) System” on page 66
▼
How to Prepare the USB Flash Drive on a Windows XP System
Extract (unzip) the contents of the downloaded syslinux- version.zip archive file.
Where version represents the Syslinux version number.
Insert the USB flash drive into a USB 2.0 port.
After Windows has found the new hardware, double-click on My Computer from the desktop.
1
2
3
1
2
3
Preparing the USB Flash Drive
Sun Installation Assistant 2.2 User's Guide for the Sun Fire X4640 Server • October 2009, Rev. A 64