Sharpvision XV-Z7000U - Manual (Page 12)

E-12
Setup & Connections
INPUT 2 NENT AUDIO INPUT
RGB /COMPONENT P R
(INPUT 1, 2)
RS-232C INPUT 1 INPUT 2 /COMPONENT AUDIO INPUT
RGB /COMPONENT P R P B Y (INPUT 1, 2)
Connecting the Projector
Connecting an audiovisual source (DTV decoder or DVD player) using the RCA input
1 Connect each RCA connector to the corresponding
INPUT 1/COMPONENT terminals on the projector.
2 Connect the other end of the cable to the corresponding
terminals of a DVD player or DTV decoder.
3 To use the built-in audio system, connect one end of an
audio cable to the AUDIO INPUT (INPUT 1, 2) terminal
on the projector.
Connect the other end to the audio output terminal on
the audiovisual equipment.
• A 3.5 mm minijack to RCA audio cable adaptor may be
necessary.
DTV decoder
or
DVD player
To audio output terminals
Audio cable (sold separately)
RCA component cable (sold separately)
To analog component output terminals
Projector
Connecting an audiovisual source (DTV decoder or DVD player)
using the 15 pin video and audio input
DTV decoder
or
DVD player
To analog component output terminals
D-sub/RCA cable (sold separately)
Projector
Audio cable (sold separately)
To audio output terminals
When connecting this projector to a DVD player or a DTV decoder, select “Component” by using RGB/COMPONENT on
the remote control or the GUI menu. (See page 25.)
When connecting this projector to a DVD player or a DTV decoder, select “Component” by using RGB/COMPONENT on
the remote control or the GUI menu. (See page 25.)
1 Connect the one end of the D-sub/RCA cable to the
INPUT 2 RGB/COMPONENT port on the projector.
2 Connect the other end of the cable to the corresponding
terminals of a DVD player or DTV decoder.
3 To use the built-in audio system, connect one end of an
audio cable to the AUDIO INPUT (INPUT 1, 2) terminal
on the projector.
Connect the other end to the audio output terminal on
the audiovisual equipment.
• A 3.5 mm minijack to RCA audio cable adaptor may be
necessary.